Shaping wall foam in Prelude

Col · Post by **Col** » Tue Apr 04, 2006 1:34 pm

Hello,

The new Preludes or even perhaps the old ones are only supplied with one section of outer wall foam next to the thigh hooks,

How do i go about shaping foam to fit the contoured side of the boat, or would i be better gettin in touch with Pyranha and gettin some more pre cut from them.

Thanks

Col

Craig Smerda · Post by **Craig Smerda** » Tue Apr 04, 2006 5:36 pm

You can make your own... a simple way is to take 1" or 2" thick sheets... cut and glue as needed. If you want to get fancy you might end up using a bandsaw to match the profile. Good luck!