A Burn C1 is Born

Decked Canoes, Open Canoes, as long as they're canoes!

Moderators: kenneth, sbroam, TheKrikkitWars, Mike W., Sir Adam, KNeal, PAC, adamin

Matt Fritz
C Guru
Posts: 112
Joined: Tue Apr 26, 2005 4:34 pm
Location: Salida, CO

A Burn C1 is Born

Post by Matt Fritz »

After watching me flip, and luckily roll up, three out of four times, above Baby Falls on the Upper Tellico in my Atom, my wife insisted that I look into geting a creek boat. I think Louie was witness to one of these flips/rolls. This was during Eli's creeking clinic. Below is the result.

This is a new Pyranha Burn large that I bought from NOC. I removed the kayak outfitting and installed mini-cell C1 outfitting using a hardwood dowel as the backbone and anchor for the thigh straps. So far, no bulkhead is needed. I did need to trim the cockpit rim a little as I am 6'5" tall, but I think the hull could still be converted back to a kayak if necessary.

The kayak with all its outfitting weighted 43 lbs before I started, and now my C1 weights 38 lbs. Not bad being 5 lbs lighter than the kayak.

See the short video below of me on a lake. What do you guys think about the trim? Right now, the small of my back is 8.5" from the outside of the back of the cockpit rim.

Matt

Short Video

http://www.geocities.com/mjfritz02/burn.wmv



[img]http://www.myfilehut.com/public/13222/DSC03290.jpg[/img]
[img]http://www.myfilehut.com/public/13223/DSC03291.jpg[/img]
[img]http://www.myfilehut.com/public/13224/DSC03299.jpg[/img]
Bob P
CBoats Addict
Posts: 770
Joined: Thu Jan 16, 2003 10:04 pm
Location: Connecticut

Post by Bob P »

Pretty close, but I'd move back an inch or two. Too much bow in the water.
Bob P
Larry Horne
C Maven
Posts: 1447
Joined: Tue Apr 13, 2004 2:39 am
Location: Northern California

Post by Larry Horne »

nice! that outfitting looks good. i'm having trouble with the video, guess i'll try later..
i've got 5 days on my new burn L and i am lovin it. it actually is an improvement on an already good design.

fyi, i'm 6', and my seat back is 8" from the back (outside) of the cockpit rim. i'm told it might be a little bow light, but i think it's good from picture i've seen...
Larry
Larry Horne
C Maven
Posts: 1447
Joined: Tue Apr 13, 2004 2:39 am
Location: Northern California

Post by Larry Horne »

i think the trim looks good where you've got it.

by the way.... a wife that insists you look into a creek boat? you are a lucky man!
Larry
User avatar
squeakyknee
CBoats Addict
Posts: 451
Joined: Wed Oct 19, 2005 12:59 am
Location: RVA
Contact:

Post by squeakyknee »

It looks good,I was wondering how that would convert over.
Looks as though there is a good amount of room in there.
I be interested to hear how it paddles compared to the H3?
Matt Fritz
C Guru
Posts: 112
Joined: Tue Apr 26, 2005 4:34 pm
Location: Salida, CO

Post by Matt Fritz »

Thanks for the replies, and yes Larry, my wife is one of a kind.
Larry Horne
C Maven
Posts: 1447
Joined: Tue Apr 13, 2004 2:39 am
Location: Northern California

Post by Larry Horne »

squeekyknee, it's the h3 tuned a little bit more towards creekin. it paddles almost the same as the h3. to me, it feels maybe a tiny bit slower, but more nimble. stability seems the same, maybe a little less initial and a little more secondary. it just feels a little bit smaller and lighter. it is easier to boof, i've been able to get the bow up on some drops that i would plug with the h3. i think it carves out of eddies better. but these are all very small differences. the big ones are; it is a lot easier to roll because the cockpit is 1.5" lower. and the bow is reshaped to make it stay up better, and resurface better when it doesn't. so far it seems to work really, really well, i've run a few big sticky ledges and i haven't plugged in yet. i did say yet, i've only had it a little while...
i think it's a great boat.
Larry
Bernie
C Guru
Posts: 186
Joined: Thu Jan 23, 2003 5:08 pm
Location: Dayton, Oh / Fayetteville, WV.

Burn

Post by Bernie »

I have the medium Burn tricked out and have the seat at 8.5" but plan to move it to 9.25" from back of the cockpit rim. This is a great river runner/ creeker but I plan to keep my M-3 for full on creekin'.
User avatar
PAC
CBoats.net Staff
Posts: 3313
Joined: Thu Nov 07, 2002 1:07 am
Location: Pittsburgh, PA

review

Post by PAC »

Hey Bernie how about a review comparison between the M3 and Burn series. Right now I've also looking at a Fink (been trying to hold out for a FatBoy) but I keep coming back to one og the P boats.
I'd appreciate it (I think others would too) and since your a Pyranha guy if you can add the H3 in the mix that would be great.
No pressure but it would be nice to here from someone who has paddled all three! Thanks in advance. Paul C.
Paul C.
Cboats Moderator
Official TOG Member (Team Old Guy)!
User avatar
the great gonzo
Paddling Benefactor
Posts: 1718
Joined: Wed Jun 18, 2003 2:03 am
Location: Montréal, Québec

Post by the great gonzo »

PAC,

I am not sure when I am going to be down in your neck of the woods next time (it will definitely be during Gauleyfest, gotta run the Upper Yough...), but I'll make sure to throw my Finkenmeister on the roof for you to try.

Cheers!

martin a.k.a. the great gonzo!

(and yeah, when the Fat Boy finally gets released, I'll buy one unseen!)
Everyone must believe in something. I believe I'll go canoeing - Henry David Thoreau
Matt Fritz
C Guru
Posts: 112
Joined: Tue Apr 26, 2005 4:34 pm
Location: Salida, CO

Post by Matt Fritz »

I know it's a creek boat, but if you want to see a Burn C1 flatspin in a hole, see the link below.

I don't have much bandwidth, so if you can't see it, try back a little later.

Matt

*** Link removed. See the next reply for new link. ***
Last edited by Matt Fritz on Mon Jun 26, 2006 3:26 pm, edited 1 time in total.
Matt Fritz
C Guru
Posts: 112
Joined: Tue Apr 26, 2005 4:34 pm
Location: Salida, CO

Post by Matt Fritz »

I found a better way to post videos. Try the link below. Let me know what you think.

Matt

http://www.youtube.com/watch?v=nmx88vBURWc
User avatar
fez
CBoats Addict
Posts: 352
Joined: Mon Jan 31, 2005 9:22 am
Location: Germany
Contact:

burn

Post by fez »

Jamie Burbeck is riding an Burn also for creeking:

[img]http://www.thamesweirproject.co.uk/imag ... adness.jpg[/img]
imagine
Matt Fritz
C Guru
Posts: 112
Joined: Tue Apr 26, 2005 4:34 pm
Location: Salida, CO

Post by Matt Fritz »

Cool picture. Thanks.

I'm liking my burn more and more. A week ago I spent three days on the Ocoee and one on the upper Tellico. For my size the burn did alot better than my Atom, especially on the Tellico. I did three laps on the Tellico and was clean on my last one.

I didn't get any video of the day on the Tellico, but below are a few from the Ocoee.

I need to work on my cross boof.

cross boof
http://www.youtube.com/watch?v=SmMLQKp7BJc

roll in a hole
http://www.youtube.com/watch?v=0gjlU1IH9Tg

alien boof
http://www.youtube.com/watch?v=YnbSlTUIzOk

side surf
http://www.youtube.com/watch?v=tpEOlVCXxr8

Matt
User avatar
fez
CBoats Addict
Posts: 352
Joined: Mon Jan 31, 2005 9:22 am
Location: Germany
Contact:

m:3 vs. burn

Post by fez »

"how about a review comparison between the M3 and Burn series" - this would be great ! I would be interested also in this comparison very much because I could get hold of an M:3 243 not too expensive....

Greetings Frank
imagine
Post Reply