Page 1 of 1
wheelboy - drain plug
Posted: Mon Aug 28, 2006 12:35 pm
by Sandie_
I am thinking of putting a drain plug in my wheelboy.
i swim a lot and spend ages getting the water out.
anyone know a good position? how many inches from the back etc?
sandie
Posted: Mon Aug 28, 2006 5:41 pm
by cbcboat
As far back as you can put it, this will get more of the water out.
Posted: Mon Aug 28, 2006 5:53 pm
by Sandie_
im worried if i go too far back there may be no cavity behind my drill hole. how much of the back is sold plastic?
..
Posted: Tue Aug 29, 2006 6:05 pm
by PAC
Sandie_ did you get my email? Paul C.
Posted: Tue Aug 29, 2006 6:12 pm
by Sandie_
Yes. but only just read it in detail.
thank you
Posted: Wed Aug 30, 2006 2:17 am
by the great gonzo
Sandie,
I just measured the position of ther drainplug in my Wheelboy, the distance is ~2 1/4 " (60mm) from the end of the boat to the center of the plug.I offset the plug to the side of the boat it is just on the inside of the crease.
The plastic is really thick in this area, well obver 1/4 ". To avoid drilling too deep and in to the bottom I recommend sticking a piece of sheetmetal in the end of the boaqt before you start to drill.
martin a.k.a. the great gonzo!