that might fit a bandit?
pretty please?
anyone have a dowel t-grip sitting around?
Moderators: kenneth, sbroam, TheKrikkitWars, Mike W., Sir Adam, KNeal, PAC, adamin
- oopsiflipped
- CBoats Addict
- Posts: 954
- Joined: Sat Jun 03, 2006 3:32 am
-
- C Guru
- Posts: 107
- Joined: Mon Jun 19, 2006 12:43 pm
- Location: Dayton Ohio
- Contact:
T-GripI have about half dozen
Oopsislipped or flipped,
I have several laying around, most are 1and 1/4 in diamiter and 4 an 1/4 long with 3/4 hole 13/16 deep. I made them to fit clinch river paddle shafts. You would have to glue it to another dowel and then insert it into the bandit shaft. Thats how I did mine and it seems to work well. I have spruce, cedar, oak, and some beautiful spalted dogwood. I assume straight with no taper. I also have the original bandit t-grip if you want it other wise you might have to do a little sanding to fit the dowel int the bandit shaft.
Whish I knew how to send pics but havent mastered that one yet. Be glad to send you something for free if you get me an address.
D-Caption
256-329-2386 call if you like
I have several laying around, most are 1and 1/4 in diamiter and 4 an 1/4 long with 3/4 hole 13/16 deep. I made them to fit clinch river paddle shafts. You would have to glue it to another dowel and then insert it into the bandit shaft. Thats how I did mine and it seems to work well. I have spruce, cedar, oak, and some beautiful spalted dogwood. I assume straight with no taper. I also have the original bandit t-grip if you want it other wise you might have to do a little sanding to fit the dowel int the bandit shaft.
Whish I knew how to send pics but havent mastered that one yet. Be glad to send you something for free if you get me an address.
D-Caption
256-329-2386 call if you like
- oopsiflipped
- CBoats Addict
- Posts: 954
- Joined: Sat Jun 03, 2006 3:32 am
- Marc Evans
- C Guru
- Posts: 241
- Joined: Wed May 11, 2005 6:01 pm
- Location: Pullman, Washington
Gabe, did you find a t-grip? If not, I'm probably mixing some epoxy tomorrow or the next day. I could put one together for you if you give me the inside diameter of the shaft and the diameter of the grip you want. If you need a comparison, just go check out the one on the door stop that I made you - it had an 1.25 inch diameter t-grip.
Marc
Marc