Gluing Minicell to Royalex

Decked Canoes, Open Canoes, as long as they're canoes!

Moderators: adamin, kenneth, sbroam, TheKrikkitWars, Mike W., Sir Adam, KNeal, PAC

Post Reply
harry56
c
Posts: 5
Joined: Fri Oct 26, 2018 2:16 am

Gluing Minicell to Royalex

Post by harry56 » Thu May 14, 2020 3:17 am

Picked up my first boat and need to re-glue the saddle to the Royalex hull. Any suggestions on glue/adhesive to use?

Also, i may need to move the kneepads which are already glued - i'm considerably shorter than the previous owner. Any recommendations on removing them gently?

Thanks!

User avatar
Kelly-Rand
CBoats Addict
Posts: 336
Joined: Wed Nov 13, 2002 6:55 pm
Location: Boston MA

Re: Gluing Minicell to Royalex

Post by Kelly-Rand » Thu May 14, 2020 4:46 pm

Weldwood Contact Cement in the red can is the best for gluing minicel to the deck. A 4" putty knife with corners rounded off with a file is one tool that I've used to lift installed minicel. I've seen some plastic scrapers that might work.
Removing minicel if you want to re-use the piece is tedious because you have to do it all carefully so you don't tear it.
Jim KR

"with single blade in hand
a C-1 I will stand"

clt_capt
C Guru
Posts: 167
Joined: Mon Jun 07, 2004 2:35 am
Location: RTP, NC

Re: Gluing Minicell to Royalex

Post by clt_capt » Fri May 22, 2020 11:30 pm

You can also use a heat gun - CAREFULLY

I would keep the heat on low and keep your heat gun moving.


You do not want to delaminate the Royalex

Post Reply